Category Archives: Bags and Baskets

Wendy’s Bag & Tutorial

Wendy’s Bag & Tutorial

A while back, my FB friend Wendy, surprised me with a selection of fabric scraps.  Thank you Wendy!  Within that, there was a small bag of Kaffe Fassett fabric scraps which were labeled as such. I knew that this fabric was special to her.

I thought about this for a long time, of a project which could integrate and make the most of these small pieces.

It wasn’t until I had made the Japanese inspired Celebration Bags Antique Style, that the idea struck that I may  have enough fabric to make a similar bag but with a different shape.

Patchwork Celebration Bags Antique Japanese Style & Tutorial

As it turned out, the maths worked perfectly for incorporating the pieces, including  the base, and as though it was truly meant to be, I had a small piece of Kaffe Fasset fabric in complementary colours with teapots which became the lining!

Perhaps you too have a set of special small scraps that you can’t part with.  No extra notions are required to make this bag, so there is no need to run to the shops for supplies.  😊You can easily  prepare to make this bag with scraps you already have.

All fabrics have been washed before commencement.  All seams are based on 1/4”.  Please read all instructions before commencement.

Requirements for Wendy’s Bag

70 of 3″ x 2 1/2″ oblongs
2 of 2 1/2″ Width Of Fabric (WOF) strips

Scrap fabric piece for the lining pieces

Assembly Instructions 
 
Take the 2 of 2 1/2” WOF strips.  Fold the long sides towards the centre.  Then fold the whole strip in half lengthways.  Pin well.  Sew down each side of the strips.  Leave one strip whole.  From the second strip, cut 12 of 2” lengths.  These will become the tabs for the closure.

Join 30 of the 3” x 2 1/2” pieces in a 5 x 6 configuration, to make an oblong 10” 1/2” x 15” 1/2” as pictured.  Repeat to make a second panel.  They will be the bag front and back.  Make sure that there is good distribution of the fabrics.  Use the remainder 10 pieces to make the bag base.  Sew them together in a 2 x 5 configuration, which will measure 5 1/2” x 10 1/2”.  Press the three panels.  Use them as a templet to cut out three matching lining pieces.

Fold each tab in half, and place down, raw edges aligning on the top edge of each of the bag front and back.  Use six for each one.  Place them evenly along the top edges, in the centre of each oblong.

Take the bag base, centre it lengthwise along the base of the front panel, right sides together.  Sew together.  Open out and attach the bag back to the other long side of the base, as pictured below.

TodayI’m sewing with this terrific Singer 201k treadle C 1947.
 Sew the side seams together.  Then sew closed, across the remaining openings at the sides of the base of the bag to make square as pictured below.
Sew all the lining pieces together in the same manner.
Insert the lining into the bag, right sides together.  Make sure all the tabs are tucked in.  Sew around the top of the bag leaving a opening of about 4” for turning.
Turn through the opening to the right side.  Tuck the lining into the bag.  Turn in the seam allowance and pin.
Top stitch carefully around the top of the bag.
Take the long strip previously sewn.  Beginning from one side of the bag tabs, thread the strip all the way around.  Knot the ends together in a decorative style.  Now the bag is ready for use.
Hopefully it will make a great sponge bag or project bag.
Have a wonderful sewing day!
Susie